Connect – Sensor

Features

• Clear display of the available components with coloured imprints
• Wire any circuits – as with conventional plug-in modules
• Electronically protected components
• Extensive digital worksheets available for Electude e-learning system

Learning content

• Getting to know vehicle-typical sensors according to equipment
• Interpret sensor-typical voltage values in vehicle-related circuits
• Multimeter and oscilloscope as measuring instruments

Recommended accessories

• Cable set Lab trainer 2mm
• Power supply TS10
• Desk frame S

Equipment

• Laboratory trainer in desk housing, for use on a table or in a DIN-A4 support frame
• 2 x fuse, switch, 5 V DC voltage source, piezo sensor as knock sensor, hot film sensor, induction sensor, Hall sensor and encoder wheel
• 2 x precision shunt, pulse-width frequency generator to control encoder wheel, 2 x temperature-dependent semi-conductor resistors (NTC, PTC)
• 3 x resistors, potentiometer, NPN power transistor, photo resistor, lamp, photo diode/photo element, pressure/force sensor
• 54 x connection sockets for wiring and measuring, 4 x sockets for power supply

Training package:

With a training package, you can get started immediately. You will receive the desired learning system with all accessories as well as the appropriate digital work orders for the device.

Connect – Sensor

After completing the practical exercises, you will be able to: recognise sensors, explain how sensors work, name the field of application of sensors, check sensors, explain measurement results, set up circuits, carry out measurements on the electrical circuits.

Course Layout

*Theory modules require a courseware license (Teach or Inspire)